Available for the first time for purchase as a component (no belt attached), our Aegis buckle (Carbon Steel, Machined/Nitrided).
Please note that if this is the first belt/buckle you've ordered with this custom artwork, you'll need to also purchase the Artwork Setup Fee (
Artwork Setup Fee - CLICK HERE).
Made from machined carbon steel, this Aegis buckle includes two stainless steel screws and one stainless steel rod (designed for belts 0.15" to 0.21" thick).
The Aegis buckle is designed for a belt approximately 1.5" wide. Wider belts will not fit. Narrower belts will fit, but will look wrong because of the extra space.
Buckles are nitrided Black.
BECAUSE THIS BUCKLE IS MADE FROM CARBON STEEL, IT WILL EVENTUALLY RUST IF NOT PROPERLY MAINTAINED. THIS BUCKLE MUST BE KEPT UNSCRATCHED AND OILED FOR MAXIMUM CORROSION RESISTANCE.
To assemble the buckle, first place the buckle on a table "belly side up". Then place the rod in the belly area of the buckle (where the engraving is). Then, insert one screw through the track of the sidewall, and screw it into one end of the rod. Repeat with second screw.
We strongly recommend you use threadlocker during final assembly.
RETURNS OF THIS ITEM WILL NOT BE ACCEPTED.
Every part of this buckle (body, screws, and rods) is made in the USA.
